A word of warning to all companies using Autodesk Fabrication ESTmep, your CAD department may be sharing all your costing and labor information without even knowing it. The Autodesk Fabrication…
The Fabulous NumPad!
Scott HendricksBet you didn’t know you could do this with Fabrication NumPad.
Design Line Node Buttons
Scott HendricksAll, autodesk fabrication, CADmep, ESTmep, Design Line, fabrication Leave a comment
New tricks to make modeling with Design Line easier.
Fabrication CADmep Positioner
Scott HendricksThe Positioner in Autodesk's Fabrication CADmep is a pretty handy little tool. Check out this video and I will show you a few things that you can do with it.
Fixed Design Line Nodes
Scott HendricksAll, CADmep, Design, Design Line, fabrication Leave a comment
Adding fall to a Design Line is a fairly simple task but here is a trick to make sure your Design Lines stay connected to your equipment after applying fall to it.
CADmep Service Validation
Scott HendricksAutodesk Fabrication CADmep has a very good tool build in for checking our models for things like duplicate items, connector mismatches, size mismatches, open ends and collisions. Check out this…
Linear Nesting of Pipe
Scott HendricksLinear nesting can reduce your material waste and lower your labor cost associated with prefabrication but the report can be tricky to setup. The video below should help you get your report working…